| cwirth |
| I was wondering if anyone has done their own oil and filter change on their Murano? I have a 2009 and don't mind doing the oil change but they really packed the engine in there. I couldn't even see the oil filter. Any DIY instructions on this? |
|
|
| Eric L. |
I imagine it would be the same as with the 1st gen Murano - drain plug and filter are on the passenger side of the engine. You can access both by turning the wheel all the way to the right and then removing the fenderwell splash guard.
Do a search - a lot of pictures have been posted on this subject. |
|
|
| njjoe |
cwirth-
I change the oil and filter from underneath, so I do not need to remove anything. It actually is relatively easy. The hardest part is reading the oil level on the dip-stick. It is all but impossible to read new oil on that shiny metal.
A word of caution... Make the sure the oil dipstick is back in place before adding new oil, otherwise it can flow out from the opening.
-njjoe |
|
|
| Gonzo |
| The MO has the easiest setup for oil changes. I don't even need to put it up on jacks or ramps. The oil filter is near the bottom so I can change the oil in under 15 minutes. |
|
|
| BikerJohn |
The MO is the easiest car I have ever own to do an oil change. When you park the car to do your change; turn your steering wheel all the way to the right(as car is moving so you don't stress your power steering system).
This will now give you access to your front passenger side wheel well where the black plastic well-sheild can be removed. This is done by removing 5 or so small black plastic "mushroom" plugs.
The oil filter is directly behind that sheild. You can also access the oil filter as others have mentioned.
However; if you go from underneath you won't be able to use the new oil filter removal tool that is available.......................
...................The Gizmo 2000 ! Have a look at this link http://www.nissanmurano.org/forums/...ight=gizmo+2000
Hope that helps; I'll try and post the photo of the "mushroom" plugs also. |
|
|
| cwirth |
quote:
Originally posted by BikerJohn
The MO is the easiest car I have ever own to do an oil change. When you park the car to do your change; turn your steering wheel all the way to the right(as car is moving so you don't stress your power steering system).
This will now give you access to your front passenger side wheel well where the black plastic well-sheild can be removed. This is done by removing 5 or so small black plastic "mushroom" plugs.
The oil filter is directly behind that sheild. You can also access the oil filter as others have mentioned.
However; if you go from underneath you won't be able to use the new oil filter removal tool that is available.......................
...................The Gizmo 2000 ! Have a look at this link http://www.nissanmurano.org/forums/...ight=gizmo+2000
Hope that helps; I'll try and post the photo of the "mushroom" plugs also.
Thanks, can you also explain how to remove the mushroom clips. |
|
|
| BikerJohn |
| To remove the plastic plugs you will need a thin flat screwdriver. Insert the screwdriver between the ridged section and twist. |
|
|
| BikerJohn |
When you twist; the center part will come outwards. Then you can pull the whole plug out.
To install; insert the plug with the center pin out and then insert into the hole.
Then push the center pin back in. Hope that helps. |
|
|
| BlueSteW8 |
The last 2 times I've used the K&N "Gold" HP1008 oil filter, and have been using Castrol Syntec 5W-30 (both available at the local Checker Auto Parts).
I order online, and pickup at the store - if your order totals $40.00 or more, you can get a $5.00 discount.
The K&N has a welded nut on the filter canister (1"?) making removal a cinch.
Otherwise, very simple to do as others have stated!
FYI - the hatch also gives access to the belts, which is very nice. |
|
|
| BikerJohn |
| The weld-nuts are great for removing tight filters but do remember to only "hand-tighten" the filter on as directed and rub a little new oil on the new filter gasket before installation:4: |
|
|
| Tahoe SC |
also consider getting a fumoto drain valve!
i have one on my wrx and on the murano...i love them...
i think with the new oil tool and the fumoto valve, i can do my wife's oil change in the living room without getting any oil on the floors!
dirt is another matter though :D |
|
|
| Eric L. |
quote:
Originally posted by Tahoe SC
also consider getting a fumoto drain valve!
i have one on my wrx and on the murano...i love them...
i think with the new oil tool and the fumoto valve, i can do my wife's oil change in the living room without getting any oil on the floors!
dirt is another matter though :D
Completely agree with the recommendation. I also have a fumoto valve and it is outstanding - makes changing oil much quicker and less messy. |
|
|
| Corin |
quote:
Originally posted by Eric L.
I also have a fumoto valve and it is outstanding - makes changing oil much quicker and less messy.
Me too. If you search for Fumoto on this forum you'll find some good info. Have one on each of our vehicles, and have recommended it to many others. Just don't let Jiffy Lube touch your car or they'll probably take it off and replace it with a non-fitting plug (and probably strip it out, too).
Using this valve, and a little tupperware container that wedges in under the oil filter to catch any drips there, I can do a full oil change without ever having one drop fall on me or my garage floor.
Well, this weekend I ALMOST had a spill-free oil change. All the way up until the end, and was pouring the old oil from the oil pan into a container. Neighbor distracted me, I looked up, and proceeded to pour dirty oil down the side of the container and all over the floor. DOH! Too bad I can't fit my "used oil" containers under the MO and just drain directly into them... |
|
|
| BikerJohn |
| Fumoto valves are great. I've had one for a while now it make oil changes very clean. I do wish that the drain hole was a little bigger for a faster drain. No problem though; I just other things while it's draining. |
|
|
| njjoe |
For those of you who use Mobil-1 and have Advance Auto Parts stores in your area, they are offering a Mobil-1 special - 5 quarts of Mobil-1 oil and a Mobil-1 oil filter for $26.98. That is a $10 saving over regular prices.
-njjoe |
|
|
| Eric L. |
That is a good deal Joe. I'll have to try to get in on it.
quote:
Originally posted by njjoe
For those of you who use Mobil-1 and have Advance Auto Parts stores in your area, they are offering a Mobil-1 special - 5 quarts of Mobil-1 oil and a Mobil-1 oil filter for $26.98. That is a $10 saving over regular prices.
-njjoe
|
|
|
| mgthe3 |
dammit
I just got 2 filters and crush washers from my dealer last week.
My 07 is hittin 8k miles now. When I change at 10k it will be her first taste of synthetic.
It had been a while since I had seen those lawn mower sized filters. |
|
|
| ekaxel |
Did a very short (for me) oil change today at 4500mi/8 mo. Had to try the new oil drain pump I got in December.
It extracted about 4 liters from the crankcase, about the same as I get on a conventional drain. Took a while (about 10 minutes), but I did other things.. It is a little less messy, still have to try the filter drain appliance mentioned in another thread. You stii have to dispose of the oil, which involves a transfer.
Usual Amsoil 0W30 Series 2000 and an Amsoil EaO36 filter |
|
|
|
