All of the pieces are removable, however, the door pieces are the only ones without screws. Just slowly insert a trim removal tool in the center most part and drag it right and left and you will hear the plastic clips release. I am sorry I forgot how many there are. The front bumper pieces have 2 screws each side (one closest to the wheel well and the other in the inner most part/corner. The inner one is the hardest to get to. I started by pulling back the wheel well liner and removing the closest screw and then used a trim removal tool to pop the other one out. When I put it back, I simply unscrewed the screw a little and then pushed it back in the hole so I did not have to actually screw it in.
It would be easier to remove the entire front bumper but I didn't want to get into that. I have not done the rear bumper yet, as there are so many screws holding all of those pieces in. I already tried and broke part of one chrome piece. I am thinking I will try to wrap it on the car. I chose to remove the other parts so I could wrap around the pieces instead of on top of them.
Hope this makes sense, it is early and I have not had my coffee. Please message me if you have issues and I will do a better DYI.