Nissan Murano Forum banner
1 - 1 of 1 Posts

·
SHIFT_ passion
Joined
·
72 Posts
Discussion Starter · #1 ·
To all those w/trouble programming homelink, try this. It should do the trick:

To reset homelink simply hold in all 3 buttons, the signal light will stay on solid, then it will blink rapidly and then go blank. Once the light goes blank, all codes are erased. To program the remote, turn key to acc. position, hold remote up to the mirror with the button pushed (remote button) and the hold in whichever homelink button you want. The light on the mirror will flash, then go solid, then out. Once this is done locate the Smart button on your motor head (usually on the front under the lightbulb) Press it and then go back to the MO and press the button on the homelink you programmed 3 long times. Door should move... I think I covered it all, once you do it It wont seem hard at all

Good luck
Mike
 
1 - 1 of 1 Posts
Top