Nissan Murano Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1 (Edited)
2007 with 135000 miles in it.


So a bit of background. I have replaced both camshaft position sensors in the couple years.. And I just had the plugs and coil packs replaced as they were going bad one at a time.
Well after I got the coil packs done my engine light went back off for 3 days. Then it came back on. I took it to AutoZone to get their tester and I got a P0011 camshaft over advanced code. That's bank 1. The first time their system recommend engine replacement. Well everyone found it odd so I cleared the codes and drive till it came back on. Took 2 days. Went back and git the same code but with a recommendation of just an oil change. Wtf is going on?
 

·
Registered
2010 MO LE AWD Platinum Silver
Joined
·
54 Posts
I’d go ahead and replace the cam shaft position sensors again and change the oil and filter . Also, I’d have the alternator and battery tested make sure those are good and your batter terminals are good and tight with no corrosion on the terminals or battery cables and go from there .
 
1 - 2 of 2 Posts
Top