Nissan Murano Forum banner

1 - 1 of 1 Posts

120 Posts
Discussion Starter · #1 ·
I did a search and have not found a good solution for the following problem...

Some @$$hole made a 2x3 inch hole in my front bumper (probably backing up with a tow-hitch), just to the side of and a bit lower than my right fog light. It is a complete puncture with a flap attached by one of its edges.

Besides replacing the front bumper cover, what are my options? I thought abour pulling out the flap, sanding and aligning its edges and joining the seams with epoxy mixed with paint, then sanding the seams... Any other options?

It would be nice if they had a body-colored urethane film that I would just apply neatly over the hole...
1 - 1 of 1 Posts