Nissan Murano Forum banner

1 - 13 of 13 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter #1
Installing an Aarm Myself - APS997

I checked the prices on installation on the Prestige APS997 Alarm. This is a two way LED paging alarm with remote start. They wanted over $630 (Includes Alarm) to do this. I can get the same alarm on the internet for $150 + $20.00 for the bipass module (needed Remote Start). I have installed alarms in the past so I am going to do this myself. I do need help from some of the experts on this forum. That is dealing with the wire diagrams and problems they have run into. I know I need a universal bipass module 556uw from directed for the remote start. I also know I need to pull the door panel off to get to the wires for the remote keyless entry (They wanted to charge me $180.00 for that). Anyway, has anyone installed an alarm on their Murano. It would be great if could post any needed wire diagram or other information that would help. Thanks in advance! Thomas
 

·
Registered
Joined
·
25 Posts
Discussion Starter #3
Thanks Enforcer! I heard these manuals are a few hundred dollars ... $20.00 is well worth it! ..... If anyone has installed an Alarm please post your expereince! .... Thanks
 

·
Registered
Joined
·
25 Posts
Discussion Starter #5
Wire Codes would be great!

Is there anything else I need to be aware of? Did you run into any problems? Thanks for your help. I will be installing it next week. ... My email address is: [email protected]

Thanks

Thomas
 

·
Registered
Joined
·
1,076 Posts
You don't need to go into the doors. You can tap the BCM.

See link:



Also these are wire codes for 2003, need two wire to start (seee note)

Murano 2003

Remote Starter Wiring Colors and Notes
Function Vehicle Color Location
Start: Black/Red & Black Yellow Ignition switch harness**
Ignition #1: Black/Red (+) Ignition switch harness*
Ignition #2: N/A Ignition switch harness
Ignition #3: N/A Ignition switch harness
Accessory: White/Blue (+) Ignition switch harness
Brake Light: Red/Green (+) Brake pedal switch
Tach Signal:
Parking Lights: Red/Blue (+) Drivers kick panel to the rear
Headlights:
OEM Alarm Disarm: N/A
OEM Alarm Arm: N/A
Diesel Glow Plug: N/A
Clutch Bypass Wire:

Notes: *This vehicle may be equipped with a Transponder Anti-Theft System. Use Universal Alarm Bypass Module part # 2x402 where X can be any number. **This vehicle is equipped with two start wires. Both must be powered in order for vehicle to start when engine is cold.


Nissan Murano 2003
Alarm and Keyless Entry Wiring Colors and Notes
Function Vehicle Color Location
Constant +12 Volts: Green (+) Ignition switch harness
Starter Kill: Black/Red & Black Yellow Ignition switch harness**
Ignition +12 Volts: Black/Red (+) Ignition switch harness*
Dome Lights/Superv: Comes on with unlock
OEM Horn: Green/Orange (-) Steering column harness
Power Lock: Blue (-) Drivers door module in door***
Power Unlock: Red (-) Drivers door module in door
Trunk Release: N/A
Alarm Input Wire: Comes on with unlock
Notes: ***See Note #201 Negative Trigger Door Locks



2004

12volts green (40A) + ignition harness
Starter black/red + ignition harness
Second Starter black/yellow + ignition harness
Ignition black/red + ignition harness
Second Ignition N/A
Third Ignition N/A
Accessory red + ignition harness
Second Accessory white/blue + ignition harness
Keysense black/red + ignition harness or BCM, pin 37
Power Lock blue - driver door module in door, pin 4
Power Unlock red (double pulse) - driver door module in door, pin 6
Lock Motor purple 5wi BCM above accelerator pedal, pin 50
Unlock Motor green/white 5wi BCM above accelerator pedal, pin 44
Parking Lights+ red/blue + driver kick, harness to rear
Parking Lights- N/A
Hazards green/red - BCM above accelerator pedal, pin 29
Turn Signal(L) green/black + BCM above accelerator pedal, pin 45
Turn Signal(R) green/yellow + BCM above accelerator pedal, pin 46
Reverse Light green/white + driver kick, harness to rear
Door Trigger see notes - BCM above accelerator pedal
Dome Supervision red - BCM above accelerator pedal, pin 48
Trunk/Hatch Pin purple/white - BCM above accelerator pedal, pin 58
Hood Pin N/A
Trunk/Hatch Release green/blue - release relay in driver kick
Power Sliding Door N/A
Factory Alarm Arm arms with lock
Factory Alarm Disarm disarms with unlock
Disarm No Unlock single pulse power unlock wire
Tachometer NOT red or black ac any ignition coil or fuel injector
Wait to start N/A
Brake Wire red/green + brake pedal switch
Parking Brake green - parking brake switch
Horn Trigger green/orange - horn switch
Memory Seat 1 lt. green/black - memory module left of column, pin 9
Memory Seat 2 pink/blue - memory module left of column, pin 25
Memory Seat 3 N/A -
Interface Modules
 

·
Registered
Joined
·
25 Posts
Discussion Starter #7
This great! Cannot find the BCM link

Thanks for the wire diagram. When I go to the link provided there is another link to the BCM instructions that does not seem to work anymore. Do you have any instructions on wiring from the BCM? Thanks!
 

·
Registered
Joined
·
1,076 Posts
Your right, the link is gone. To bad, it had nice pics and described several nissan/infinity model installs.

Basically,

lock/arm is pin 13 (BCM). If it doesn't work try pin 11.
disarm/domelight turnon/double-purse unlock is 14
Does not control windows like the OEM remote.

NOTE:
Both 13 and 14 should be empty on the 40-pin plug of the BCM.
orange/red wire is pin 15.

strip 5/8-3/4" of insulation off wires, insert into slots and tightly zip-tie to other wires in plug.

Good Luck.
 

·
Mr. 3 K, 3/3/5. 5K,10/5/7
Joined
·
4,994 Posts
BigGun Great Info!!

I enjoyed just reading it.

:)
 

·
Registered
Joined
·
1,076 Posts
Thanks Grip!

It's the least I can do for all the hours of reading enjoyment you have provided us over the years.
 

·
Registered
Joined
·
25 Posts
Discussion Starter #11
Location of the BCM

So the BCM is located above the accerlator pedal. Is it easy to find? Just want to make sure I am taping into the correct wires. I have a 2003 Nissan so I assume the 2004 wire list that has more detail is the same? Thanks for all your help.
 

·
Registered
Joined
·
6 Posts
o4 murano has seperate door triggers. I tagged the parking light by taking the drivers rocker panel and trimming a small piece out of the plastic protector to find the wire.
 

·
Registered
Joined
·
1,076 Posts
The BCM is up to right of steering wheel column.
Route your remote starter's lock wires right along side the ignition wires.
 
1 - 13 of 13 Posts
Top