Nissan Murano Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
136 Posts
Discussion Starter #1
I remember several months ago someone wrote about ordering keys and fobs online cheaper than dealer price. I did a seach but couldn't find it. Anybody remember this.

(After it came out of the pool it worked for one day then quit:confused: )
 

·
Premium Member
Joined
·
7,280 Posts
XOC said:
I remember several months ago someone wrote about ordering keys and fobs online cheaper than dealer price. I did a seach but couldn't find it. Anybody remember this.

(After it came out of the pool it worked for one day then quit:confused: )
They sell a lot of them on e-bay.
 

·
Registered
Joined
·
136 Posts
Discussion Starter #3
Programming instructions?

Thanks I did find a decent price there although I am an e-bay virgin --this could be the time to take the plunge. But the guy wants $4.99 for program ming proceedures:rolleyes: . Can anybody help me out with this?
 

·
Registered
Joined
·
2,393 Posts
Take it to the dealer and tell him it quit.

If you do go to ebay, ABSOLUTELY DO NOT BUY from a seller named "mylocksmith". He has low prices, but looks like a real crook!
 

·
Registered
Joined
·
424 Posts
1. Close all doors

2. Insert key into ignition and remove it from the ignition key cylinder more than six times within 10 seconds.
(Your Hazard Lamps will flash if you have performed this step successfully.)
NOTE: Withdraw key completely from ignition cylinder each time.
NOTE: If this procedure is performed too fast, system will not enter programming mode.

3. Insert key into the ignition cylinder and turn to the ACC position.

4. Within 5 seconds, push ANY button on the remote transmitter ONCE.
(Hazard Lamps will flash twice).
At this point, the oldest ID code is erased and the new ID code is entered.

NOTE: Do not press the button more than one time in the above step.
If the button is pressed more than one time, the programming procedure will not be successful.

5. A maximum of four ID codes may be entered.
If more than four ID codes are entered, the oldest ID code will be erased.
If there are any remaining transmitters (including the old ones), follow steps 6 and 7 for each transmitter.

6. Lock doors using the driver's side power lock/unlock switch

7. Push any button on remote controller once (do this within 5 seconds)
(Hazard warning lamps will then flash twice)
At this time, the oldest ID code is erased, and the new ID code is entered.

8. Open Driver's side front door after ALL keyfob's are programmed.
 

·
Registered
Joined
·
136 Posts
Discussion Starter #6
Thank you so much CopperKat!
 
1 - 6 of 6 Posts
Top