Nissan Murano Forum banner
1 - 3 of 3 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
Hello friends,

I took a door from a compost to change my busted door... it is of driver side.
I want to change out the lock cylinder to keep away from the requirement for another key.
There is an attached rod to the lock cylinder that I have un-connected. I have even eliminated a holding clip.
Now I suppose I am close. Can’t pull it out from the outer side because it is very bulky. Can’t pull in from the inner side because there is an attached "cap" that is very big to fit throughout the hole.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.