[FastEddy]

Im getting ready to run new wire to the front doors. The rears were easy just pop out the rubber tube on the body side and fish them.

The fronts are an issue. I disconnected the wire harness and it doesn't look like I can run a wire. There is a rubber grommet on the body side that looks like it will pop out. I could slit the existing large boot on the door side and run the wire from there to the hole that the grommet is covering.

What have you guys done for the fronts?

 

[gseepes]

On the body side, there is a hole about an inch below the rubber grommet. I ran the my wire out of that, and cut into the door side rubber. I never see it.

 

[FastEddy]

Cool.
I was concerned that it may get pinched. Looks like ill be doing the same.
Thanks.

 

[gseepes]

drivers side front door