Wheel speed sensor

185 Views 1 Reply 2 Participants Last post by I need coffee, 6 d ago

Stoical

Discussion Starter · 6 d ago

I had to change my wheel bearings. NM 2010. Awd. Had to drill out the wheel speed sensors .. both sides because they were corroded into the hub. Replaced bearings and sensors, now my abs light and my traction control light will not go out. Do I need to reset it via obd? Anyone know of the best obd reader for nissan murano?

Save

1 - 2 of 2 Posts

I need coffee

· #2 · 6 d ago

Stoical said:
I had to change my wheel bearings. NM 2010. Awd. Had to drill out the wheel speed sensors .. both sides because they were corroded into the hub. Replaced bearings and sensors, now my abs light and my traction control light will not go out. Do I need to reset it via obd? Anyone know of the best obd reader for nissan murano?

Assuming there's nothing wrong with the replacement sensors, those lights should turn off after driving the car for a while as the ABS control module confirms it can read the signals coming from them. Otherwise, disconnecting the battery ground cable for a half hour or so should do the trick.

Save

1 - 2 of 2 Posts

Top Contributors this Month